MMS03.001 SGW Bypass Universal Cable for IXI and FLEX

The new MMS03.001 SGW Bypass universal cable for IXI and FLEX is necessary for identification, reading, and writing operations on Continental EMS314x and EMS316x engine units.

Installed on Renault, Dacia, Nissan, and Mitsubishi vehicles: this cable allows programming without the need to remove the unit from the vehicle.

Control units supported by the new MMS03.001 cable are:

– Continental/Vitesco EMS3140 – OBD (SGW Bypass), Bench

– Continental/Vitesco EMS3141 – OBD (SGW Bypass), Bench

– Continental/Vitesco EMS3160 – OBD (SGW Bypass), Bench

– Continental/Vitesco EMS3161 – OBD (SGW Bypass), Bench

– Continental/Vitesco SID321 – Bench (For IXI only: the cable enables connection even without the vehicle)

OBD mode (SGW bypass) – Connection procedure:

To begin with, connect the crocodile clips to the battery or charger. After that, locate the CAN lines of the vehicle by following the manual available in our software. Once you have identified the lines, proceed to connect the programmer to the female OBD port of the cable to initiate the programming process.

Bench mode – Description:
In addition, the new SGW bypass universal cable allows programming through Bench protocols when connected in Bench mode. Furthermore, this setup enables access to the unit even if the vehicle is not in the workshop, since there are no SGW modules present between the ECU and the programmer.

Bench mode – Connection procedure:
Initially, connect the crocodile clips to any charger. Then, use the included adapters to connect directly to the control unit’s connector. Finally, attach the programmer to the female OBD port of the cable for a seamless connection.